GRID LINE (GriLin)

Type: Interactive/Batch Application

Grids existing line(s)

Detailed Description

Grids existing line(s) by placing points on line. Points may be placed by linear distance from the start of the line, on the coordinate system X or on the coordinate system Y. Original points on the lines may be deleted, deleted except for the first and last points or may be left unmodified. The elevation of the new points are interpolated based on the point before and after the new point.

Local Commands

None

Parameters

The following parameters are used when gridding line in interactive and batch modes. Pressing button 7 allow the entry of these parameters.

Grid distance

Defines the gridding distance. This parameter is entered in ground units.

Insert mode

Defines the action to be taken on the existing line points.

Don’t delete any existing points	The original points on the line are left unmodified.
Delete original points except endpoints	Original points on the line are deleted except the first and last point.
Delete all original points	All original points are deleted. The only points left on the line are the points inserted by this application.

Grid mode

Defines the point insertion mode.

Grid linear along line	Points are inserted linearly along the line starting from the first point on the line
Grid on coordinate system X	Points are inserted on the coordinate system X.
Grid on coordinate system Y	Points are inserted on the coordinate system Y.

The following parameters are used when batch reversing a layer:

Layer of lines to grid

Defines the layers to search when gridding lines. A number line may be entered here

Workspaces to consider

The current workspace or all open workspaces may be searched when gridding lines.

NOTE: Lines in layers that are turned off will not be considered even if they are specified.

Button Assignments

Grid Line – Lock on

	Button	Description
1	Id line	Identifies line to grid
2	Grid layer	Runs in batch mode
3
4
5
6
7	Enter params	Allows entry of grid line parameters
8
9
*
0
#	End	Ends application