Grid Line

Grids existing line(s) by placing points on line. Points may be placed by linear distance from the start of the line, on the coordinate system X or on the coordinate system Y. Original points on the lines may be deleted, deleted except for the first and last points or may be left unmodified. The elevation of the new points are interpolated based on the point before and after the new point. An optional Duplicate Point Distance may be set to keep new points from being placed too close to existing line points.

Key-in	Description	Range
INSMOD=	Defines the action to be taken on the existing line points	0 = Don’t delete any existing points 1 = Delete original points except end points 2 = Delete all original points
GRIMOD=		0 = Grid linear along line 1 = Grid on coordinate system X 2 = Grid on coordinate system Y
GRIDIS=	Defines the gridding distance	Real number - Ground units
DUPDIS=	Duplicate point distance. New points that are within this distance of an existing line point will be considered duplicate and will not be placed on the line.	Real number - Ground units
LAY=	Layers to search for lines to grid	Number line
WSTC=	Workspaces to consider	0=Current 1=All
RUN	Run grid lines in layer mode

The following parameters are used when gridding line in interactive and batch modes. Pressing button 7 allows the entry of these parameters.

Don’t delete any existing points	The original points on the line are left unmodified
Delete original points except end points	Original points on the line are deleted except the first and last point
Delete all original points	All original points are deleted. The only points left on the line are the points inserted by this application.

Grid linear along line	Points are inserted linearly along the line starting from the first point on the line
Grid on coordinate system X	Points are inserted on the coordinate system X
Grid on coordinate system Y	Points are inserted on the coordinate system Y

Duplicate Distance. New points that are within this distance of an existing line point will be considered duplicate and will not be placed on the line. This parameter is entered in ground units. A value of zero disables the use of this parameter when inserting points on the line.

Defines the layers to search when gridding lines. A number line may be entered here.

The current workspace or all open workspaces may be searched when gridding lines.

NOTE: Lines in layers that are turned off will not be considered even if they are specified.

	Button	Description
1	Id line	Identifies line to grid
2	Grid layer	Runs in batch mode
3
4
5
6
7	Enter params	Allows entry of grid line parameters
8
9
*
0
#	End	Ends application